Matchbox RC2

[eluser]zdknudsen[/eluser]
Adods and gh0st: matchbox urls and default controllers are both explained in the introduction page on http://matchbox.googlecode.com

The controllers themselves work like they always have. However, the way you store and access them are slightly different. At its simplest this is how it works.

www.example.com/module/controller/method/parameter

1. The first segment represents the module in which the controller can be found.
2. The second segment represents the controller that should be invoked.
3. The third segment represents the method that should be called.
4. The fourth, and any additional segments, represents the variables that will be passed to the controller.

As you may have noticed the only difference from the standard style is the module segment in front. There are two exceptions, though.

1. If the controller is located in a subfolder then the subfolder must be added as another segment between the module and controller segments.
2. If the controller have the same name as the module, the controller segment can be omitted.
3. If the controller is in a subfolder and have the same name as the subfolder, the controller segment can be omitted.

Please note the second and third exceptions which explain how to omit the module segment (e.g. a default controller).

Where to send GET/POST is up to you and has nothing to do with Matchbox